Discount Coupon Network - Discount Coupons & Coupon Codes

1/2in Keyless Chuck Cordless Drill/Driver
Available at The Eastwood Company for only $ 146.99 (USD)
IQv Series 19.2-Volt 1/2in Drill-Driver features: 650 in-lbs stall torque Less than 45 lbs with Lithium Ion battery 0-360-1300 rpm Charger and batteries sold separately 3 year Warranty

Bearing Race And Seal Driver
Available at The Eastwood Company for only $ 39.99 (USD)
When installing seals and bearing races, it is critical to drive them in correctly. If not driven in perfectly square, seals could leak and bearings can fail prematurely. Includes six easily changed discs and an aluminum drive handle. Use the flat side of the discs to drive seals, use the tapered side to drive races.

1/2in Keyless Chuck Cordless Drill/Driver
Available at The Eastwood Company for only $ 133.99 (USD)
IQv Series 14.4-Volt 1/2in Drill-Driver features: 550 in-lbs ideal stall torque 0-360-1300 rpm Less than 43 lbs with Lithium Ion battery 17 position ball clutch for total tightening control 3 year Warranty Charger and batteries sold separately

Bearing Race & Seal Driver Master Set
Available at The Eastwood Company for only $ 49.99 (USD)
Bearing Race and Seal Driver Master Set - Install wheel bearing race and seals without damaging race and axle housings. Includes drive andle and the following 9 drivers for bearing race OD's measuring: 1565", 1.750", 1.965", 2.325", 2.470", 2.555", 2.830", 2.995", and 3.180". Limited 1 year manufacturer's warranty. Imported.

Skin Zipper Air Hammer Driver Door Skinning Tool
Available at The Eastwood Company for only $ 29.99 (USD)
Designed with steel shaft and self lubricating nylon head Form and crimp at 45 degree angles Inlcudes two slot sizes for thick or thin metal skins Head skins must be replaced after ten door treatments Two side slot widths are included for thick or thin sheet metal skins.

Flywheel Turner
Available at The Eastwood Company for only $ 14.99 (USD)
Turning an engine over to remove clutch or torque converter bolts is tough. Stop using an old rag and prying with that old bent screw-driver! Get the right tool!